Supplies
- Piece of leather or faux leather
- 3/8” - 1/2” snap
- Mallet
Designs Used
Cutting Instructions
1
Load the leather cuff file into your cutting machine’s software. This bracelet can be scaled to fit any wrist size. Measure the wrist with a tape measure, and then add 1 1/2” to that measurement to make room for the snap and allow for some extra room for comfort when wearing. This will be the final length needed for the bracelet. Then use the design software to make the bracelet that final length.
2
Once the file is sized, proceed in the design software until the shape is ready to be cut. Make sure the proper knife tool is in place.
3
Smooth the leather onto the adhesive mat with the right side of the leather facing up. For leather or faux leather, increase the pressure of the machine’s blade on the cutting machine until it is suitable for the leather.
4
Cut out the bracelet, and then carefully remove the bracelet and the leftover fabric.
Crafting Instructions
1
Follow the manufacturer’s instructions for the snaps to add the snap pieces onto each end of the bracelet.
