Shadowbox Bear Bank | Cutting Machine & Laser Cutting | Craft Genesis - Print

Shadowbox Bear Bank

Supplies

  • .125” MDF material
  • .125” acrylic

Products Used

  • Shadowbox Bear Bank (Laser Cutting) (Sku: CM79032-1)

Steps To Complete

Crafting Instructions

1

To start, take one of three pieces labeled as C. Glue this piece to piece G (the engraved back piece), matching all appropriate edges.

2

Stack and glue another C piece on top of the first.

3

Stack and glue pieces D-1 and D-2 on top, aligning them with their corresponding sides. These pieces create the coin slot.

4

Glue the final C piece on top of the previously glued layers.

5

Next, glue engraved acrylic piece A on top of the assembled base.

6

Finally, glue piece B on top of the engraved acrylic.

7

To finish, glue base piece D to the bottom of assembled bank.

8

After giving the glue from previous steps time to fully dry, take piece F and slide it into the slot at the bottom of the bank. When it is time to retrieve coins from the bank, simply pull piece F out to create an opening.